Raspberry Pi Pico Hat
Die 10 besten Produkte von Dezember 2025
Letzte Aktualisierung:
8. Dezember 2025
GeeekPi
GeeekPi Raspberry Pi Pico/Pico W UPS Power Supply Uninterruptible UPS HAT,Support 18650 Lithium Battery Charger Power Bank Power Management Expansion Board for Raspberry Pi Pico/Pico W
16% Rabatt
Kostenloser Versand
99
MAXIMALE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#1 GEWINNER
▼ Mehr anzeigen
▲ Weniger anzeigen
Dies ist ein tragbares Netzteil nur für Raspberry Pi Pico/Pico W.Plug & Play.
Unterstützt nur 18650 Lithiumbatterien („18650“ ist eine Bezeichnung für die Abmessungen einer Batterie. Die Ziffernfolge „18650“ gibt den Durchmesser und die Höhe der Batterie an: „18“ steht für einen Durchmesser von ca. 18,0 mm, und „650“ bezeichnet eine Höhe von ca. 65,0 mm.)
Die verbleibende Batterieleistung kann an den 4 LED-Anzeigen abgelesen werden. Sie können auch Batteriespannung und Strominformationen lesen, indem Sie das USB-zu-TTL-Kabel an die Pins des seriellen Anschlusses der USV anschließen.
Die Ladeaufforderung während des Ladevorgangs ist sehr intuitiv, und wenn der Akku vollständig aufgeladen ist, wird der Ladevorgang beendet und die „Standby-Anzeige“ auf dem Bedienfeld leuchtet auf.
Alle GPIOs führen nach außen und bieten klare Siebdrucke, die für Pico-Experimente sehr praktisch sind.
10,90 € AUF AMAZON
FREENOVE
Freenove Breakout Board for Raspberry Pi Pico 1 2 W H WH, Terminal Block Shield HAT with Pin Header, GPIO Status LED
Kostenloser Versand
98
MAXIMALE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#2
▼ Mehr anzeigen
▲ Weniger anzeigen
Compatible Models: Raspberry Pi Pico / Pico H / Pico W / Pico WH / Pico 2 / Pico 2 W (NOT included in this kit)
GPIO Status LED: LED on if GPIO outputs / inputs high level, LED off if GPIO outputs / inputs low level
Independent LED: The status LED is driven by the chip instead of the GPIO so the GPIO will not be affected
Terminal Block and Header: Connect to all pins of Raspberry Pi Pico, 2.54 mm (0.1 inch) pitch
Pin Name: The name of each Pin is printed next to it
14,95 € AUF AMAZON
UeeKKoo
1.3inch IPS LCD Display HAT Compatible with Raspberry Pi 5/ 4B/3B+/3B//A+/Zero W/WH/Zero 2 W/Pico/Pico 2W, etc. 240 x 240 Pixels, SPI Interface, with Embedded Controller
96
BESTE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#3
▼ Mehr anzeigen
▲ Weniger anzeigen
This is an IPS LCD display HAT Compatible with Raspberry Pi, 1.3inch diagonal, 240x240 pixels, with embedded controller, communicating via SPI interface. Trying to add a control interface for your Pi? This compact display would be the ideal choice.
IPS screen, wide viewing angle, better display. High definition in small size. 1x joystick, 3x pushbuttons, handy and useful.
Driver: ST7789. Interface: SPI. Display color: RGB, 65K color. Backlight: LED. Operating voltage: 3.3V.
Comes with Online resources and tutorials to help you get started quickly: bit.ly/3gcUJWw
20,15 € AUF AMAZON
Raspberry Pi
Raspberry Pi Pico 2, RP2350 Mikrocontroller-Board
Kostenloser Versand
91
HOHE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#4
▼ Mehr anzeigen
▲ Weniger anzeigen
Dual Arm Cortex-M33 oder Dual RISC-V Hazard3 Prozessoren bei 150 MHz CPU
520 KB On-Chip SRAM; 4 MB On-Board QSPI Flash
2 × UART, 2 × SPI-Controller, 2 × I2C-Controller, 24 × PWM-Kanäle, 1 × USB 1.1-Controller und PHY, mit Host- und Geräteunterstützung, 12 × PIO-State-Maschinen
26 Mehrzweck-GPIO-Pins, darunter 4, die für ADC verwendet werden können
21 mm × 51 mm
5,99 € AUF AMAZON
FREENOVE
FREENOVE Universal Breakout Board Compatible with Arduino Nano Micro Raspberry Pi Pico 1 2 W ESP32 ESP8266, Terminal Block Shield HAT with Pin Header, GPIO Status LED, 5 V 3.3 V
Kostenloser Versand
86
SICHERE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#5
▼ Mehr anzeigen
▲ Weniger anzeigen
Compatible Models: Any board (5 V or 3.3 V) with a pin spacing of 0.1 inch (2.54 mm), width 0.6, 0.7, 0.8, 0.9, 1.0 inch and length up to 2.3 inch (24 pin) (Compatible with Arduino Nano / Micro, Raspberry Pi Pico 1 / 2 (W), ESP32, ESP8266)
Power Supply: If using DC input (6~24 V), can provide 5 V and 3.3 V power (DC-DC circuit, up to 3A); otherwise, can use the power of the main board (Need to configure jumper caps, please refer to the tutorial)
GPIO Status LED: LED on if GPIO outputs / inputs high level, LED off if GPIO outputs / inputs low level
Independent LED: The status LED is driven by the chip instead of the GPIO so the GPIO will not be affected
Terminal Block and Header: Connect to all pins of the main board, 2.54 mm (0.1 inch) pitch
15,95 € AUF AMAZON
Coolwell
DC Motor Driver Module HAT for Raspberry Pi Pico Series, Driving Up to 4X DC Motors, I2C Controlled, up to 3A Output
82
SICHERE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#6
▼ Mehr anzeigen
▲ Weniger anzeigen
Standard Raspberry Pi Pico header, supports Raspberry Pi Pico series
I2C controlled, supports 32x different I2C addresses by setting the 5 address jumpers
Onboard PCA9685 chip, provides 12-bit hardware PWM to adjust motor speed
Onboard TB6612FNG dual H-bridge motor driver, high efficiency, low heating
Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal; Breakout unused pins of Pico for easy extension
16,95 € AUF AMAZON
Raspberry Pi
Raspberry Pi Pico W, (SC0918)
Kostenloser Versand
81
GUTE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#7
▼ Mehr anzeigen
▲ Weniger anzeigen
RP2040 Mikrocontroller-Chip, entworfen von Raspberry Pi im Vereinigten Königreich
Dual-Core ARM Cortex M0+ Prozessor, flexibler Takt bis zu 133 MHz
264 kB SRAM und 2 MB integrierter Flash-Speicher
On-Board-Single-Band-2,4-GHz-Wireless-Schnittstellen (802.11n)
26 multifunktionale GPIO-Pins
6,99 € AUF AMAZON
SEENGREAT
264X176, 2.7inch E-Ink Display HAT for Raspberry Pi/Raspberry Pi Pico/Jetson Nano/Arduino/STM32 2.7-Inch E-Paper HAT Two Color Black White SPI Interface
Kostenloser Versand
76
GUTE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#8
▼ Mehr anzeigen
▲ Weniger anzeigen
Epaper display HAT for Raspberry Pi, onboard Voltage Translator, which can be compatible with 3.3V and 5V MCUs
Epaper display module, onboard two buttons and two LEDs, making it convenient for users to expand their applications.
Eink display module, based on Pi 40PIN GPIO header design, applicable for Raspberry Pi series motherboard
E-ink display HAT, SPI communication interface is reserved to facilitate connect to Arduino/STM32 and other control boards
Open source demo codes available for Raspberry Pi, Raspberry Pi Pico (with Pico interface for directly connection), Arduino, STM32, ESP32 development boards
23,95 € AUF AMAZON
Coolwell
RP2350-ETH Mini Development Board, RP2350 Ethernet Port Module, Dual-core & Dual-Architecture Microcontroller, Compatible with Raspberry Pi Pico HAT, CH9120 TCP/IP, Onboard Flash Memory, GPIO Pins
Kostenloser Versand
72
GUTE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#9
▼ Mehr anzeigen
▲ Weniger anzeigen
Powerful RP2350 Microcontroller: Equipped with the RP2350 dual-core & dual-architecture chip designed by RPi, integrating Arm Cortex-M33 and Hazard 3 RISC-V processors, clocking up to 150 MHz.
Seamless Ethernet Integration: Features the CH9120 chip with a built-in TCP/IP protocol stack, offering reliable Ethernet connectivity and enhancing IoT development capabilities.
Ample Memory and Storage: Includes 520KB SRAM and 4MB onboard Flash memory, providing robust resources for complex embedded systems and applications.
Versatile GPIO Compatibility: 14 multifunctional GPIO pins compatible with some Pi Pico HATs, and 12 Programmable I/O (PIO) state machines for creating custom peripherals.
User-Friendly Design: Supports drag-and-drop programming via USB mass storage, with a castellated module for easy soldering and onboard features like a temperature sensor for advanced functionality.
22,07 € AUF AMAZON
KEYESTUDIO
KEYESTUDIO Raspberry Pi PICO IO Shield for Raspberry Pi Pico Development Board
14% Rabatt
Kostenloser Versand
66
GUTE QUALITÄT
AUF AMAZON ANSEHEN
Amazon.de
#10
▼ Mehr anzeigen
▲ Weniger anzeigen
This Raspberry Pico IO shield is designed for the Raspberry Pi Pico development board. Note Raspberry Pico is Not Included!
It also incorporates communications ports like 2 x I2C, 2 x UART, 2 x SPI, 3 x analog IO and 13 x digital IO as well as a 6.5-12V power interface.
On board with four block building holes can assist to wire up multiple sensors or modules, which exceedingly increases more functions.
DC input voltage: 6.5-12V ; Output voltage: DC3.3V V
There are 26 GPIO pins, so you will be motivated to create what you want to make.
11,99 € AUF AMAZON
pi pico hat
pico raspberry pi
raspberry pi pico
raspberry pi pico radio
raspberry pi pico 2wh
raspberry pi pico lcd
raspberry pico lora hat
raspberry pi pico case
raspberry pi pico 2350
raspberry pi pico kamera